Camshaft Position Connector 3 PIN BMW 12527507257 with Wires

Component description and its role

A complete repair plug with wires intended for the camshaft position sensor and the manifold absolute pressure (MAP) sensor. The kit is used to replace a damaged connector along with a section of wires, allowing for a quick restoration of electrical system functionality.

Construction and parameters

• Connector type: 3-pin
• Number of wires: 3 pieces
• Wire length: approximately 15 cm
• Wire colors: may vary depending on the batch
• Application: camshaft position sensor, manifold absolute pressure (MAP) sensor

Application in BMW vehicles

The plug is found in many BMW models that use camshaft and MAP sensors with a 3-pin connector, including:

• BMW Series 1 (E81, E82, E87, E88)
• BMW Series 3 (E46, E90, E91, E92, E93)
• BMW Series 5 (E39, E60, E61)
• BMW Series 7 (E38, E65, E66)
• BMW X1 (E84)
• BMW X3 (E83, F25)
• BMW X5 (E53, E70)
• BMW Z3
• BMW Z4 (E85, E86, E89)

When is it worth using this kit?

The product is applicable when:

• the original plug is melted, cracked, or corroded,
• wires have been broken or heavily worn,
• there are reading errors from the camshaft position sensor or MAP,
• a quick repair is needed without replacing the entire engine harness.

Advantages of use

• easy installation due to ready-made wires,
• sufficient wire length facilitating adjustment,
• sealing of connections protecting against moisture and dirt,
• possibility of use with both camshaft and MAP sensors,
• practical solution for repairing the electrical system.