SM2 PRO J2534 VCI ECU 67-in-1 interface

Versatility and Compatibility

Chiptuner PRO J2534 VCI is a device that supports 67 different ECU modules and over 200 new protocols, such as Bosch MED and EDC17. By using the J2534 standard, the device works with many popular diagnostic packages – just connect it to start working.

Main Features

• Reading and writing flash memory and EPROM in OBD2, bench, and boot modes
• ECU cloning with automatic checksum correction
• Chip tuning (Stage 1–3)
• DSG / TCU tuning – modification of transmission control units
• Launch control (LC) – activation of launch control
• IMMO off – deactivation of the immobilizer
• ADBlue off – disabling the AdBlue system
• DPF off – disabling the particulate filter
• DTC off – removal of errors from the diagnostic memory
• Vmax – removal of the maximum speed limit
• Swirl off – deactivation of swirl flaps
• Advanced ECU service and maintenance
• Ability to adjust drivetrain parameters

Supported Operating Modes

• Bench mode – reading capability without the need to disassemble the ECU
• Boot mode – full access after opening the ECU
• OBD2 – diagnostics and programming via the vehicle's diagnostic connector

Selected Supported ECU Units (without the need to open the casing)

• Simos 12.1 / 12.2
• Simos PCR2.1
• FCA GPEC2 / 2A / 4 / 4LM
• Hyundai / Kia SIM2K-240 … SIM2K-305
• MT86
• Ford / Land Rover SID208 (flash read)
• Scania EMS S8 BAM – 3-point connection via PCB with VIA holes, without removing the gel
• PSA SID208
• Mercedes-Benz SID307 / SID309 / SID310
• SDI21.x
• Mitsubishi E6T83xxx / E6T32xxx
• Isuzu Transtron SH72544R
• L4.3
• Hino EDC7UC31
• Great Wall DCM6.2AP

Additional Information

• The device operates in plug-and-play mode – no registration or activation is required
• Ability to revert to the previous controller in case of incorrect update – the device does not get locked

Technical Specifications

• Housing material: ABS + metal
• Power supply voltage range: 100 – 240 V AC

Included Items

• Chiptuner PRO J2534 VCI ECU programmer
• 1 × OBD mode cable
• 1 × Bench mode cable
• 1 × USB cable
• 1 × USB key (dongle)
• 1 × power supply
• Digital version of the software

Device for Professionals – Important Warning

The equipment is intended for professional use only. Operating the device for modifying maps in the ECU requires advanced technical knowledge and experience in working with automotive electronics. Incorrect use, lack of proper procedures, or basic ignorance can lead to permanent damage to the engine control unit (ECU), and in extreme cases, to immobilization of the vehicle. Before taking any action, one should thoroughly study the topic and be aware of the risks. The purchase and use of the device is at your own risk.